DTXMX Flysky FS-i6 6 Channels 2.4G RC Transmitter and Receiver FS-iA6B Radio Controller for Helicopter Quadcopter FPV Drone

The transmitter and receiver have been pre-bound earlier than supply. In case you are utilizing a special transmitter or receiver, observe the steps under to hook up with the receiver’s B/VCC port.
1, Join the included binding cable to the receiver’s B/VCC port.
2, Plug the DC 4V-6.5V energy provide into different ports, the constructive and adverse poles can’t be wrongly linked.
3, Hold urgent the “BIND KEY”, after which activate the transmitter to enter the binding mode.
4, The transmitter will show the RX voltage, meaning the binding is profitable.
5, Take away binding wire, Verify the operation of the servos. If one thing would not work as anticipated, begin this course of from the start.

FS-i6 Specs:
*Pushing the left throttle stick up and down doesn’t robotically return to heart
Channels: 6 CH
Mannequin Kind: Multirotor/Fastened Wing/Heli
[Parameters can be set to support quadcopters, although there is no quadcopter icon in the TX menu.]
RF Vary: 2.40-2.48GHz
Mark width: 500KHz
RF Energy: Lower than 20dBm
2.4GHz system: AFHDS 2A and AFHDS
Code sort: GFSK
Sensitivity: 1024
Low voltage warning: lower than 4.2V
DSC connector: PS2; Output: PPM
Charging Port: No
Transmitter weight: 392g
Transmitter measurement: 174x89x190mm
Packing measurement: 23.5 x 21.2 x 10.6cm
Package deal Weight: 676g
Energy: 6V, 4 x AA battery (not included)
Show mode: STN transflective constructive sort, 128 x 64 dot matrix VA73 x 39mm, white backlight.
On-line replace: sure
Certification: CE, FCC
Mannequin Recollections: 20
Management vary: 500m【It is dependent upon the utilization atmosphere, climate and different elements】

FS-iA6B Specs:
Channels: 6CH
RF vary: 2.408 – 2.475 GHz
Band:135
RF Energy: ≤20dBm
RX Sensitivity: -105dBm
2.4G system: AFHDS 2A
Code sort: GFSK
ANT size: 26mm * 2 (twin antenna)
Enter energy: 4.0-6.5V DC
Dimension: 43x26x15mm
Weight: 16g
i-bus interface: Sure
Information Acquisition Interface: Sure
Mannequin Kind: Multirotor/Fastened Wing/Heli
Appropriate Transmitters: Appropriate with FS-i6, FS-I6X, FS-I6S, FS-i4

Contents of supply:
1 x FS-i6 Transmitter
1 x FS-iA6B receiver
1 x Binding Cable
1 x Guide【EN & CN】
Assist PWM/PPM/i.bus, activate PPM: Press and maintain the “OK” button on the precise facet of the display screen for two seconds to enter the distant management menu-System-RX Setup-PPM Ostput setting to show it on or off. Press and maintain the “CANCEL” key on the precise facet of the display screen for two seconds to avoid wasting. Then the place of FS-IA6B receiver CH1 outputs PPM.

Related to a Excessive Sensitivity Receiver, This Radio System Ensures a Jamming Free Lengthy Vary Radio Transmission Every Transmitter Has a Distinctive Id, When Binding with a Receiver, The Receiver Saves That Distinctive ID and Can Accepts Solely Information From The Distinctive Transmitter.
Dependable, interference free 2.4GHz AFHDS 2A sign operation.
6 Channels. PWM/PPM/i.bus help, one transmitter for a number of functions. Flip PPM on or off through Transmitter menu-System-RX Setup-PPM. The transmitter solely makes use of 4 * AA batteries. (Supply doesn’t embrace battery)
This radio system makes use of low energy digital elements and delicate receiver chip. The RF modulation makes use of intermittent sign thus decreasing much more energy consumption.
Word: the FLYSKY FS-I6 is Left hand throttle (Mode 2), the throttle stick won’t return to the middle up and down.